Lower Fork Axle Sleeve Sets (used with the Lower Fork Base

Axle Sleeves are available as 3 part sets. All three parts are the same OD and different on the ID:

One is non-threaded. It is used in the middle of a dual leg setup.
The second has a recess for the Allen Bolt Head. It is used in a dual leg setup.
The third is threaded on both ends. It is used by itself for single leg mounting (shown below). It is also used in dual leg mounting on the outside.

Here is a cross section view of a Dual Fork Leg Setup.

Note - The Upper Dual Fork Mount is required for dual setup.

Most forks require two different diameters to mount a pair of fork tubes.

TSDY FAM20 - 20mm -

TSDY FAM22 - 22mm -
TSDY FAM25 - 25mm -
TSDY FAM26 - 26mm -
TSDY FAM27 - 27mm -
TSDY FAM28 - 28mm -
TSDY FAM30 - 30mm -
TSDY FAM32 - 32mm -

Complete Set

Or save a bit and get the complete set including all 8 sets (24 sleeves) listed above.

TSDY FAMS01 20-32mm -

SINGLE FORK LEG SETUP

 

This is a combination of:
Lower Fork Base - TSDY FAMB01 and
a single Fork Axle Sleeve - TSDY FAM Series

DUAL FORK LEG SETUP

This is a combination of:
Lower Fork Base - TSDY FAMB01 and
two Fork Axle Sleeve Sets - TSDY FAM Series (two, because the left and right are usually different diameters).